Bit Fit and Sizing
  Loading... Please wait...
  • CALL US ON 0439825670
  • My Account
  • Gift Certificates

Horse Bit Fit & Sizing

Getting the right fit for your Horse Bits!


Ensuring you have the right size and fit of your new or current bit is very important.  A bit that is too large will move from side to side and this can cause cuts, sores or damage to both the lips and inside the mouth.  A bit that is too large is not working correctly in the mouth and is not helping you to transmit clear aids as the rider.  A bit that is too small will be pinching or squeezing the horse's face and can again cause discomfort and damage.

Measuring your horse

The simplest, easiest and quickest way to accurately measure your horse's mouth size is to use a BitFit Measure.  An easy to use plastic tool, this will give you an accurate measurement in inches or cm's.  You can buy one from our Bitting Accessories page for just $30.  A very useful tool for any horse owner!

 bitfit-horsenotext.jpg  bitfitweb2.jpg


If you don't have a BitFit Measure, you can use a piece of dowel or string but you may need a friend to help mark the measurements across.

Be sure to place whichever measure you use in the mouth where the bit will normally sit to get an accurate measurement.

Measuring your bit

If your current bits fits well, you can use that size as a guide when shopping for a new bit.  To correctly measure your bit's size lay your bit on a flat surface.  Use a ruler or measuring tape and measure along the mouthpiece of the bit, from the inside of the ring to the inside of the ring, as illustrated below.  Measuring along the entire mouthpiece (to the outside of the rings) is incorrect.

See the illustration below for the correct areas to measure for mouthpiece width and ring diameter.

Bits are made either in cm's (metric) or inches (imperial) depending on their country of origin.  Inches and cm's don't always convert perfectly, so if looking for a new bit take your measurements in both.

 bitmeasuring.jpg

Does the bit fit?

How do you know if your bit fits your horse?

For a single jointed bit, you need to leave almost 1 cm on each side between the rings and the horse's lips with the bit at rest in the mouth.  This is because as the contact is taken up, a single jointed bit shortens in the mouth and the rings come closer to the lips and side of the face, as you need to allow enough width in the bit for this movement.

For a double or lozenge jointed bit, you can have the lips sitting just next to the rings or cheeks as when a contact is taken up, the rings will move evenly away from the lips.  If you have 1cm on each side between the lips and the rings in a Neue Schule, Sprenger or any french or double jointed bit it is too large for your horse and will be uncomfortable and ineffective.

 neue-schule-bit-fit2.jpg  neue-schule-bit-fit.jpg

A correctly fitting Neue Schule bit showing the lips sitting close to the rings at rest.

For a straight bar or unjointed bit (such as pelham, weymouth etc) the lips should sit just touching the cheeks of the bit when at rest.  Any larger and the bit will slide from side to side and be uncomfortable and ineffective.

Myler bits will sit differently again.  The shape of the mouthpiece means than more than usual will appear outside the mouth at the corners of the lips, desigend  to prevent any pinching to the lips.

Generally, your weymouth bit is 1/4" smaller than your snaffle/ bridoon size, as it sits lower in the mouth at a narrower part of the jaw.  So if shopping for a double set the first time, you would buy your bridoon the same size as your current snaffle and the Weymouth a 1/4" smaller.  (eg: a 5.5" snaffle means a 5.5" bridoon and a 5.25" weymouth).

For more information or if you are unsure if your new bit fits, please contact us.


 

Recent Updates

Newsletter